How to start a scooter the first time
The scooter has been received and installed, finally the long awaited moment from the scooter. The desire to stick the key into the hole, press the button and hear the hum of the engine is irresistible in the area ...
But you must resist. Although the above sounds ideal, is not the case. Imagine a car that was parked for six months, can not begin on the first try. In this case we can have a scooter for 6 months or more in addition to talking to one of the traveledSea for 2 or 3 weeks, carburetor love fresh salt air of the sea.
This article aims to help first time scooter owners begin their scooters without blowing really nothing.
Do's and Don'ts:
1 If 50 or 150cc scooter, look no electric start on the first kick until
2 Do not try at all costs, to help launch the scooter
3 Avoid the use of a charger. The engine recharges the battery when it starts. When the charger is used, there is a mandateMotorcycle battery charger set at no more than 2 amps
4 If the scooter is equipped with an alarm system, do not you try to start the alarm or the remote control to start the scooter
Buy 5 more expensive than gasoline and fill the reservoir all the way up
6 Do not use fuel additives or detergent solution Carburetor
7 Once the scooter is started, be ready for them at least 15 minutes to charge the battery - Run the engine battery is by far the best
Remember that a new batteryvery fragile. If you scroll to the bottom, it can cause permanent damage and damage other components, such as the regulator fuses, voltage and / or CDI. To protect the battery and other components, 50cc and 150cc scooters all should be initiated with the first kick start and then try the e-start a couple of times, as described below.
Since most 250cc scooters do not have a kick start, 250cc scooter owners should follow the electric starter.
StartProcedure:
1 Fill the tank available throughout the route with the best fuel
2 Place the bike on center stand
3 Check to see if the kill switch is directed towards the circle, not the X
4 If the scooter came with remote control, double-click a row UNLOCK
5 Turn the key to
6 Speed up the throttle all the way and keep it open 1 second, repeat 3 times
7 Turn the KickStart, pressing gently with the remaining half of the foot
8 Let the starter Soccergo
9 Penalty kick starter make a strong 3 or 4 times in a row that the starter goes to the bottom and goes all the way every time
10 Then the acceleration all the way (point 6) and keep you awake all the way home a couple of times (Step 9)
11 do not occur simultaneously and to speed
Try the e-start only after they tried to start the bike, as described previously described with the kick-start.
Electric boot process:
1 Follow steps 1 through 6 in the procedure to startabove
2 Hold the rear brake
3 Turn the throttle to compensate for the lack, not to speed, keep the game
4 Press the start button for 3 seconds and
5 Speed all the way and let go, to keep the lots from the gas
6 Press the start button for 3 seconds and
7 Let the electric motor cold start for 30 or 40 seconds and repeat the steps above again.
May start to overheat and damage the electric motor to motorblows the starter, backup and other parts of electrical devices.
If the bike does not start, do not try the e-start the process of more than 2 times, but returned to start the procedure and repeat 2 or 3 times. It may take several attempts, starting in the second or more bikes Attempt 3.
If all else fails:
Some scooters have a hard time starting my. This can be attributed to several factors. In 90% of cases, failure to start is to get as fuel to non-existent or inadequateCarburetor. The easiest way to control and cure them, is to fill the carburetor manually:
1 Open the seat
2 Loosen the cover screw of the carburetor (usually just one screw)
3 Remove the cover and locate the carburetor
4 The top of the carb looks like a dome with two metal screws to hold it
5 Remove the two screws at the top of the carburetor
6 Place 3-4 tablespoons of fuel directly into the carburetor
7 Replace the top of the carburetorand fasten with two screws
8 Follow the E-start only if the procedure is not followed more than 3 times, if not kick off
If the scooter does not start, are those with limited mechanical skills and those who have just enough knowledge to be dangerous, they are encouraged to use the technical support department of the dealer scooter was made in which the purchase or ask a mechanic motion professionals contacted.
